To connect the equipment
Once properly installed, to connect the Progeu or the Full Progeu, simply set the timer;
Full Proger in verifying the correct voltage of power network and choose the same key picker in the framework of command.
Important: the registration of filter should be open;
Water must be above the minimum;
Both the Progeu as Progeu Full, automatically regulate the water level of the pool;
If the pump compartment is flooded, call a technician before switching it.
To filter your pool
Remove the adapter and the pre-filter;
Put the clean filter element;
Open record to filter;
Connect the equipment setting the timer;
Follow the table beside.
To drain (empty) pool their
Your pool can be emptied by a technician (not insist).

To aspire your pool

Put the filter element. Open the record of the filter and close the drain;
Put the hose and adapter in the pre-filter;
Connect the equipment;
Pass the vacuum slowly to the bottom of the pool where there is the dirt;
If the suction becomes too weak, wash the filter element and repeat after the operation;
At the end of the aspiration, remove the adapter and the pre-filter.
To aspire draining

Your pool should be well filled;
Open the register and close the drain of the filter;
Put the pre-filter and the adapter in the hose;
Aspire as quickly as possible not to waste water.
Note: With the proper use of PROGEU this operation is unnecessary: "Save Water".
To wash the filter element

Turn the inside of the filter and wash it with water jet;
The fabric can be brushed.
Note: In this operation, are consumed only 20-40L of water. "Save Water".

To check if the filter element is working, put it in the pool and stop it.
Water must flow with ease.

Note: If water is retained in the filter element is because the filter is saturated (dirty) or flocculants was applied in the water (in this case, look for the dealer).